Four-Faith Industrial IP MODEM(DTU) successfully applied in industrial boiler remote monitoring system
Industrial boiler is an important basis equipment for the national economy and people's life, it has been widely applied to factory power, building heating and people's lives, it’s also the large energy consumption and important source of pollution. Coal-fired industrial boilers in China to maintain a large quantity, wide distribution, high energy consumption, heavy pollution, the overall level of energy efficiency has a large gap compared with developed countries, energy-saving emission reduction potential. Industrial boiler is the major energy consumption in China and a major source of pollution, the total energy consumption accounted for the national coal consumption 30%. "The 11th Five- Year" end the average efficiency of boilers in China is about 65%, lower than the international advanced level of 10% to 15%. To maintain a healthy state of boiler operation, it is necessary to strengthen the daily running status monitoring, to deal with and adjust operation mode.
Four-Faith communication customer in Guangzhou, a department of energy management and monitoring system integrators, provide boiler intelligent monitoring and after-sales service management system service. Recent for Guangzhou customer operation of boiler project, because boiler location is dispersed, the mobile boiler also need according to the change of specific tasks, change the location at any time, so the GPRS transmission method is most suitable. As of February this year customer has been to the Four-Faith communication ordered more than 500 units F2103 GPRS IP MODEM (DTU), as the boiler monitoring system data transmission terminal.
In the industrial boiler with the temperature, pressure, smoke, water hardness and other sensors, as long as the boiler start-up, the sensor will automatically collect various data of boiler operation, and through Four-Faith F2103 IP MODEM (DTU) wireless communication terminal, connect wireless network real-time transmission to the customer’s remote monitoring center . Management center through the analysis of the system provides real-time curve display monitoring index, histogram, pie chart, data report, once found running data of any abnormal or deviation, the system automatically to the after-sales service personnel to send mail or information, can be timely for those run abnormal equipment s to provide "therapy".
System topology:
Guangzhou customer project on-site picture:
